![]() ![]() It is expected that this will improve housekeeping practices and safety for workers on scaffolding, especially when dismantling scaffold.Īdditional information has been included in the code on specific hazards:.This new section provides clarity on responsibilities for making sure the scaffold is free of objects, debris and hazardous substances.There are also risks from hazardous substances. Falling objects can pose a significant risk and have caused serious injuries to workers on scaffolding, especially when dismantling scaffold. Many different trades and workers use a scaffold during the life of a construction project. The principal contractor or person with management and control of a construction site has ultimate responsibility for ensuring systems are in place to maintain a safe work environment on the scaffold and that each PCBU leaves the scaffold without risks to health and safety. Sixty six percent of the workers’ compensation claims for falls from height are serious claims requiring five or more days off work.Īdditional information has been included to clarify that each PCBU using the scaffold is responsible for cleaning up any mess, waste and spills when they have finished using the scaffold. Falls from heights are the most common cause of injuries to scaffold workers.Minimising the step height is expected to reduce the risk of fall injuries in the industry.This creates a significant risk of a slip, trip or fall hazard especially as workers may be turning and bending to access the work platform from the scaffold stair while carrying tools and equipment.Ī cost-effective way for industry to meet this new requirement involves replacing existing 1.5 metre stair modules with 2 metre modules. This creates an issue with the final step height from the scaffold stair, on to the working platform being approximately 500 millimetres. Scaffold stairs modules are typically 1.5 metres vertically in height on scaffolds which usually have 2 metre lift heights. This only applies where there is a change in direction between landings. Section 2.7.1.1 applies to stand-alone scaffolding where erection commences 12 months after 1 July 2021.Ī new recommendation that the step height from the scaffold stair module on to the working platform should be minimised so that it is no more than 300 millimetres. The new section on Step heights has a delayed commencement. Key changes in the Scaffolding Code of Practice 2021 Amendment to advise that where it has been identified non-destructive testing (NDT) for cracks in high stress areas of suspended scaffold components is needed to identify cracks not easily visible, the NDT should be conducted every three years.This section will have a delayed commencement and will only apply to stand-alone scaffolding where erection commences 12 months after 1 July 2021. A cost-effective way for industry to meet this new requirement involves replacing existing 1.5 metre stair modules with 2 metre modules. A recommendation that the step height from the scaffold stair module on to the working platform should be minimised so it is no more than 300 millimetres when there is a change in direction between landings.One means of access and egress should be suitable for emergency stretcher access. Requirement for two means of access and egress for external perimeter scaffolds over a certain size, excluding detached dwellings.These recommendations are based on the level of risk and largely reflect current industry practice. A new table recommends when an engineer, rather than a scaffolder or competent person, should design, verify and undertake the initial inspection of various scaffolds.Key changes include (but are not limited to) the following: The Scaffolding code of practice 2021 (PDF, 1.63 MB) commenced 1 July 2021 following a review of the Scaffolding Code of Practice 2009 by an industry steering group. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |